NOTE: Each time you open the battery case, check the rubber seal. Make sure the seal is seated in the groove and there is no dirt or debris on it. If the rubber seal looks worn or damaged, contact customer service to order a replacement (see the back cover page for contact information).

5.Install the alkaline battery case in your radio just as you do the Li-Ion battery (see page E-13).

WARNING! The case is designed to prevent the accidental charging of alkaline batteries. Never use alkaline batteries in the radio without the battery case. Do not attempt to modify the battery case design.

Mounting the Charger

You can mount the charger on any flat surface.

1. Use the two holes at the base of the charger as a template to mark the drill holes.

2. Using a 1/8-inch (or 3 mm) drill bit, drill two holes 1/2 inch (13mm) deep.

3. Use the provided screws to attach the charger to the surface.

Charging the Battery

Your radio includes a charger and a rechargeable battery pack. Place your radio in the charger with the display facing forward. Make sure that the CHARGE LED on the charger turns orange.

Cautions:

Use only the battery and charger supplied with this radio. Using a different charger or battery can damage the radio and create a risk of fire or shock.

Uniden MHS125 Radio Owner’s Manual

E-15

Page 19
Image 19
Uniden MHS125 owner manual Mounting the Charger, Charging the Battery