2.Press the 1/2.5/5W button to switch to the next transmission power level (for example, from 5 Watt to 2.5 Watts; from 2.5 Watts to 1 Watt, or from 1 Watt back around to 5 Watts).

3.The display shows the new transmission power in the lower left hand corner. The transmit power remains at the new setting until you change it again.

Note: Don’t forget to change the transmission setting back to 1 Watt when you move close to other stations.

Some channels (for example, channels 13 and 67) limit the transmission power to 1 Watt. When you tune to a limited-power channel, the radio automatically switches to 1 Watt. See the channel lists starting on page E-23 for a list of power-restricted channels.

In an emergency, if you press and hold the Push to Talk switch while briefly pressing the1/2.5/5W button, the power level changes from 1W to 5W for a Li-Ion battery or from 1W to 2.5W for alkaline batteries.

Setting the UIC Channel Mode

The radio comes preset to use the channels assigned for the US. If your current area uses Canadian or international channel assignments, press the UIC-Lockkey to rotate through the US, Canadian, and international channels.

Using the Strobe SOS Light

You can use this radio in an emergency. If you turn on the strobe SOS high-intensity LED light on your radio, your radio will blink “S O S” in international Morse Code. This will make it easier for rescuers to find you faster.

Your radio operates normally when the SOS LED strobe is activated.

Uniden MHS125 Radio Owner’s Manual

E-19

Page 23
Image 23
Uniden MHS125 owner manual Setting the UIC Channel Mode, Using the Strobe SOS Light