Storing Caller ID messages in the Phonebook
Messages shown in the Caller ID list can be stored in the phonebook (see page 51). The phone number and name of the party on the Caller ID list can be stored in memory.
1)When the phone is in standby mode, select the Caller ID message to be stored.
2)Press the EDIT soft key. Press volume up/down to select Store into PB?, and then press the OK soft key.
3)Store/Edit Name appears.
If the Caller ID message is already stored in memory, you will hear a beep and This data is already stored!! appears. The number will not be stored.
4)To complete the setting, follow the steps
Storing a Redial Record
1)With the phone in standby mode, press redial/p (or redial/pause on the base) in standby mode.
2)Press volume up/down repeatedly to display the number to be stored.
3)Press the EDIT soft key.
4)Press volume up/down to choose Store into PB? , and
then press the OK soft key.
5) To complete the setting, follow the steps
note
•If a call comes in via a telephone system that does not offer Caller ID service, no information is stored.
•If the Caller ID message was received as a private/unknown number, or the message does not have the number, you cannot store the message in the Phonebook. If it was received as private/ unknown name, the message will be stored as <No Name>.
•Even if all 100 memory locations are full, the message will be stored in the Phonebook.
However, the message will be erased from the Caller ID list.
S E T T I N G U P T H P H O N E B O O K
w w w . u n i d e n . c o m | S E T T I N G U P T H E P H O N E B O O K [ 4 4 ] |
E