Uniden UBC9000XLT manual ~ ~ fim~, Installing the Ctcss Board

CTCSS Operation

This section applies only if you are installing and using an optional CTCSS Tone Board with your scanner.

Installing the CTCSS Board

Installing the CTCSS Tone Board is a simple procedure, and requires only a few minutes following the steps below.

CAUTION: Be sure to turn the scanner off and disconnect the power cord before attempting to open the scanner.

1. Remove the five screws from the top cover.

Lift

~-	.~
	:.elf- - ~
@
~ ~ fim~	:5<0)
	~

2.Carefully lift the cover up from the back of the unit and turn it to the left - being careful not break the speaker wire.

3.Stand the cover on its left side panel. (Continued, next page)

45

I

. I

T