Operation
DAILY OPERATION
The hopper and stove top will be hot during operation; therefore, you should always use some type of hand protection when refueling your stove.
Never place your hand near the auger while the stove is in operation.
In the event of a power outage, the stove WILL NOT function. It is very important that unit be vented properly (with outside air), as the natural draft is needed to clear the smoke from the stove during a power outage. If the unit was ON when the power outage occurred, one of the following will take place:
1.) If the stove is still warm, it will resume feeding fuel and continue to operate normally. If the fire has gone out, you
will have to press the 
button and then the 
button again to begin a new
2.) If the stove has | button and the |
unit will begin a new |
|
NOTE: The unit will also shut down in the event of an exhaust blower failure; if this is the case, the unit will not
SAFETY AND CONVENIENCE FEATURES
Your stove includes an
starter gel, etc.) is not necessary. By simply pressing the 
button on the digital control panel, your stove will begin to feed fuel and automatically start within 3 to 5 minutes. 
For safety, this stove incorporates a safety pressure switch that helps ensure that everything is in proper working order before feeding fuel to the burn pot. Because the stove works using an induced draft pressure, the stove will not continue to operate if the viewing door is left open; or if the exhaust blower fails or the exhaust system is blocked.
The temperature limit control (Thermodisc) will prevent your stove from operating at abnormally high temperatures. Should the stove temperature reach the factory
Maintenance
Failure to clean and maintain this unit as indicated can result in poor performance and safety hazards.
Unplug your stove’s electrical cord prior to removing the back panel or opening the exhaust system for any inspection, cleaning, or maintenance work.
Never perform any inspections, cleaning, or maintenance on a hot stove.
Do not operate stove with broken glass , leakage of flue gas may result.
EXHAUST SYSTEM
The by products of combustion contain small particles of fly ash. Fly ash will collect in the exhaust venting system and restrict the flow of flue gases. Incomplete combustion, such as during startup, shutdown, or incorrect operation of the stove will lead to soot formation which will collect in the exhaust system. Therefore, it is important that the exhaust system be inspected and cleaned at least monthly during the burning season.
Check the clean out tees periodically to determine the required cleaning schedule. 3 or
USSC | 13 |
