SEARCHING FOR YOUR CODE
If your TV, VCR or DVD Player, Cable Converter, or Audio Component does not respond to the Millennium 4 after trying all of the codes listed for your brand, or if your brand is not listed at all, try searching for your code. For example, to search for a code for your TV:
1.Turn on your TV.
2.On the Millennium 4, press and hold SETUP until the LED blinks twice, then release SETUP.
3.Enter 9 - 9 - 1.The LED will blink twice.
4.Aim the remote control at the TV and slowly alternate between pressing POWER and TV. Stop when the TV turns off.
NOTE: In the search mode, the Millennium 4 will send IR codes from its library to the selected component, starting with the most popular code first.
5.Press SETUP once to lock in the code.
6.To search for the codes of your other components, repeat steps 1 through 5, but substitute the appropriate key (i.e., VCR, CBL, or AUDIO) for the (VCR or DVD, Cable, or Audio) component you are searching for.
CHECKING THE CODES
If you have set up the Millennium 4 using the Searching For Your Code procedure, you may need to find out which
1.Turn on your TV.
2.On the Millennium 4, press and hold SETUP until the LED blinks twice, then release SETUP.
3.Enter 9 - 9 - 0.The LED will blink twice.
4.To view the code for the first digit, press 1 once. Wait 3 seconds and count the number of LED blinks (e.g., 3 blinks = 3) and write down the number in the leftmost TV Code box below.
NOTE: If a code digit is “0”, the LED will not blink.
5.Repeat step 4 three more times for remaining digits. Use 2 for the second digit, 3 for the third digit, and 4 for the fourth digit. Finish writing down the code in the TV Code boxes below.
6.To check for the codes of your other components, repeat steps 1 through 5, but substitute the appropriate key (i.e., VCR, CBL, or AUDIO) for the (VCR or DVD, Cable, or Audio) component you are checking. Write down the codes in the appropriate boxes below.
TV Code
VCR (or DVD Player) Code
CBL Code
AUDIO ___________________ Code
Page 12 of 15
