Universal Electronics Millennium 4 manual Installing Batteries, Programming Tv Control, Page 4 of

INSTALLING BATTERIES

1.On the back of the Millennium 4, push the tab and lift off the battery cover.

2.Obtain two (2) fully-charged AA alkaline batteries. Match the + and – marks on the batteries to the + and – marks in the battery case, then insert the new batteries.

3.Press the battery cover back into place. The tab should click when the cover is locked.

4.Test the unit by pressing POWER and any mode key (e.g. AUDIO,VCR, TV, or CBL). If the batteries are inserted correctly, the LED will blink once.

NOTE: Whenever batteries need replacement, the Millennium 4 will blink twice with every key press. Simply replace the batteries and the Millennium 4 will be restored to its full functionality, complete with your favorite settings.

PROGRAMMING TV CONTROL

NOTE: If you own a TV/VCR combination, skip this section and perform “Programming TV/VCR Combo Control” on page 8.

Locate the brand name of your TV in the Setup Codes for TVs in the next section, and write it in the space below.

TV Brand: __________________________________

The brands are listed in alphabetical order with the most popular codes listed first. You will use one of these codes to program the Millennium 4 to operate your TV:

1.Turn on the TV.

2.On the Millennium 4, press TV once. Press and hold SETUP until the LED blinks twice, then release SETUP.

3.Enter the first four-digit code for your TV. If you perform this procedure correctly, the LED will blink twice.

NOTE: If the LED did not blink twice after entering the code’s last digit, then repeat steps 2 through 3 and try entering the same code again.

4.Aim the Millennium 4 at your TV and press POWER once. The TV should turn off. If it does not respond, repeat steps 2-3, trying each code for your brand until you find one that works. If it still does not work, try searching for the code (see Searching For Your Code on page 12).

5.Write your TV code in the boxes below for future reference.

NOTE: Remember, to use the Millennium 4 to operate your TV, press TV first.

Page 4 of 15