TROUBLESHOOTING
PROBLEM: LED does not blink when you press a key.
SOLUTION: Replace the batteries with two (2) new AA alkaline batteries (see page 4).
PROBLEM: LED blinks when you press a key, but home entertainment component does not respond.
SOLUTION: Make sure you are aiming the Millennium 4 at your home entertainment component and that you are within 15 feet of the component you are trying to control.
PROBLEM: The Millennium 4 does not control home entertainment components or commands are not performing properly.
SOLUTION: Try all listed codes for the component brand being set up. Make sure all components can be operated with an infrared remote control.
PROBLEM: TV/VCR combo does not respond properly.
SOLUTION: Use the VCR codes for your brand. Some combo units may require both a TV code and a VCR code for full operation (see page 8).
PROBLEM: No volume on a second TV.
SOLUTION: Follow instructions in Changing Volume Lock (see page 14).
PROBLEM: CH+ ,
SOLUTION: Due to RCA design
PROBLEM: Changing channels does not work properly.
SOLUTION: If original remote control required pressing ENTER to change channels, press ENTER on the Millennium 4 after entering a channel number.
PROBLEM: Tried “Search Method” and still could not find a working code.
SOLUTION: Try the “Search Method” again after clearing out the device key as follows: Press and hold SETUP until the LED (red light) blinks twice, then release. Next enter 9 - 9 - 2.Then press and release the device key to be cleared twice.
PROBLEM: Remote control does not turn on Sony or Sharp TV/VCR Combo.
SOLUTION: For power on, these products require programming TV codes on the Millennium 4. For Sony, use TV code 0000 and VCR code 0032. For Sharp, use TV code 0093 and VCR code 0048.
ADDITIONAL INFORMATION
The Millennium 4 does not have any
For help via the Internet, visit us at:
cable.rcinfo.com
(do not type in http:// or www before the address)
For help via
CableHelp@ueic.com
Copyright 2002 by Universal Electronics Inc. No part of this publication may be reproduced, transmitted, transcribed, stored in any retrieval system, or translated to any language, in any form or by any means, electronic, mechanical, magnetic, optical, manual, or otherwise, without the prior written permission of Universal Electronics Inc.
Page 15 of 15
