Universal Electronics Millennium 4 manual Programming the TUNE-IN Keys for Specific Channels

PROGRAMMING THE “TUNE-IN” KEYS FOR SPECIFIC CHANNELS

The Millennium 4 includes three “Tune-In” keys (located directly below the PAGE keys). Each can be programmed to remember three of your favorite channel settings for a total of nine channels. If you want to change the channels in a previously-programmed “Tune-In” key, you’ll need to clear the key first (see below).

To Program a “Tune-In” Key:

1.On the Millennium 4, press and hold SETUP until the LED blinks twice, then release SETUP.

2.Enter 9 - 9 - 5.The LED will blink twice. Then select a “Tune-In” key and press it once.

3.Press CBL once followed by the channel number to be programmed (e.g., 3 – 9).

NOTE: If you are programming a channel for a Digital Cable Converter, you need to enter all channels in a 3-digit channel format. For example, if the desired channel is 39, then enter it as 0 – 3 – 9.

4.Press and hold SETUP until the LED blinks twice, then release SETUP.

5.To add another channel, repeat steps 1 through 4 substituting the new channel to be added in step 3.

*NOTE: Programming more than three channels onto the same “Tune-In” key will overwrite previous settings.

To Clear a “Tune-In” Key:

1.On the Millennium 4, press and hold SETUP until the LED blinks twice, then release SETUP.

2.Enter 9 - 9 - 5.The LED will blink twice. Then select a “Tune-In” key you want cleared and press it once.

3.Press and hold SETUP until the LED blinks twice, then release SETUP.

4.This “Tune-In” key is now clear and ready for reprogramming (see above – To Program a “Tune-In” Key).

5.If desired, repeat steps 1 through 4 to clear another “Tune-In” key.

Page 13 of 15