Universal Electronics Millennium 4 Programming Cable Converter Or Dbs Receiver Control, Page 9 of

PROGRAMMING CABLE CONVERTER (OR DBS RECEIVER) CONTROL

The Millennium 4 is preprogrammed at the factory to operate the cable converter given to you by your cable company. However, if you have another brand or model of cable converter or satellite receiver that you would like to control, then you’ll need to perform the following instructions to unlock the cable key, enter in a new code, and lock the cable key again.

To Unlock the CBL Key:

1.Turn on the Cable Converter or DBS Receiver.

2.On the Millennium 4, press CBL once. Press and hold SETUP until the LED blinks twice, then release SETUP.

3.Enter 9 - 9 - 7.The LED will blink twice.

4.Press CH- once. The LED will blink twice.

To Program the CBL Key:

1.On the next page, locate the brand name of your Cable Converter in Setup Codes For Cable Converters, or DBS (Direct Broadcast Satellite) Receiver in Setup Codes For DBS Receivers, and write it in the appropriate space below.

Cable Converter Brand: ________________ or DBS Receiver Brand: __________________

The brands are listed in alphabetical order with the most popular codes listed first. You will use one of these codes to reprogram the Millennium 4 to operate your Cable Converter or DBS Receiver.

2.On the Millennium 4, press CBL once. Press and hold SETUP until the LED blinks twice, then release SETUP.

3.Enter the first four-digit code for your Cable Converter or DBS Receiver. If you perform this procedure correctly, the LED will blink twice.

NOTE: If the LED did not blink twice after entering the code’s last digit, then repeat steps 2 through 3 and try entering the same code again.

4.Aim the Millennium 4 at your Cable Converter or DBS Receiver and press POWER once. The unit should turn off. If it does not respond, repeat steps 2-3, trying each code listed for your brand until you find one that works. If it still does not work, try searching for the code (see Searching For Your Code on page 12).

5.Write your Cable Converter or DBS Receiver code in the boxes below for future reference.

Device Type:________________________

NOTE: Remember, to use the Millennium 4 to operate your Cable Converter or DBS Receiver, press CBL first.

To Lock the CBL Key:

1.On the Millennium 4, press CBL once. Press and hold SETUP until the LED blinks twice, then release SETUP.

2.Enter 9 - 9 - 7.The LED will blink twice.

3.Press CH+ once. The LED will blink twice.

Page 9 of 15