Universal Electronics OCAP 5 manual Blink twice

www.urcsupport.com/atlasocap

16

Performing these instructions will set inde- pendent volume control for all programmed devices.

Atlas OCAP M1056.fm Page 16 Wednesday, April 30, 2008 2:52 PM

NOTE: The audio mode’s (AUD) volume controls are active regardless of Volume Lock settings. However, if you lock the volume controls to the AUD mode, you will have control of the audio device’s volume in all other modes (i.e., VCR, DVD, TV, and CBL). This can be an advan- tage if, for example, you always listen to home entertainment devices through your receiver’s speakers.

Unlocking Volume Control for a Single Device (Individual Volume Unlock)

1.Assuming Global Volume Lock is active, select

a mode on the remote control that you want to unlock (e.g., CBL) and press it once. Next, press and hold SETUP until the device key blinks twice.

2.Enter 9 9 3. The last-selected device key will blink twice.

3.Press VOL- once. The last-selected device key

will blink four times.

4.Repeat steps 1 through 3 for each device you want volume to be unlocked.

Now, after you select a device that has volume unlocked (e.g., CBL), pressing VOL+, VOL-,or MUTE, will control only that device’s volume.

Unlocking All Volume Control (Global Volume Unlock) NOTE:

1.	On the remote control, press and hold SETUP
	until the last-selected device key blinks twice.

2.	Enter 9 9 3. The last-selected device key will
	blink twice.
3.	Press VOL+ once. The last-selected device key
	will blink four times.