Universal Electronics OCAP 5 manual Programming Macro Keys, Programming a Macro Key

Atlas OCAP M1056.fm Page 18 Wednesday, April 30, 2008 2:52 PM

4.Perform the instructions under “Programming Device Control” on page 10 to program device control for the desired cable converter or satellite receiver.

When you are done, perform steps 5 and 6 on this page to again lock the cable ID Lock.

5.On the remote control, press CBL once; it will blink once. Then press and hold SETUP until

the CBL key blinks twice.

6.Enter 9 8 2. The CBL key will blink twice,

indicating ID Lock is again locked.

PROGRAMMING MACRO KEYS

The Atlas OCAP 5-Device Remote Control includes two macro keys (located directly below the MUTE and LAST keys). Macro keys allow you to set up key macros to activate certain keys in a specific order. For example, you can set up a key macro to change the channels on your TV, raise or lower the volume, and start recording on your VCR, all with the touch of one key. If you want to change the macros stored in a previously-programmed macro key, you’ll need to clear the key first (see “Clearing a Macro Key” on page 19).

Programming a Macro Key

1.On the remote control, press and hold SETUP

until it blinks twice.

2.Enter 9 9 5. The SETUP key blinks twice.

3.Select a macro key (for example, F1) and press it once.

4.Press the key sequence you want to program

into the macro. For example, to turn on your TV and raise its volume, press TV followed by VOL+.

www.urcsupport.com/atlasocap

18