Universal Electronics OCAP 5 manual Programming Cable ID Lock

Atlas OCAP M1056.fm Page 17 Wednesday, April 30, 2008 2:52 PM

Locking Volume Control To One Mode (Global Volume Lock)

NOTE: The audio mode’s volume controls are active regardless of Volume Lock settings. However, if you lock the volume controls to the AUD mode, you will control the audio device’s vol- ume in all other modes (i.e., VCR, DVD, TV, or CBL). This can be an advantage if, for exam- ple, you always listen to home entertainment devices through your receiver’s speakers.

1.On the remote control, press and hold SETUP

until the last-selected device key blinks twice.

2.Enter 9 9 3. The last-selected device key will blink twice.

3.Select a mode (e.g., TV or AUD) which you

want to use to control the volume. The selected device key will blink twice.

Now, when you press VOL+, VOL-,or MUTE, the volume of the selected device (e.g., TV) is controlled regardless of mode.

PROGRAMMING CABLE ID LOCK

The Atlas OCAP 5-Device Remote Control is locked at the factory to operate your cable provider’s set top box. However, if you have another brand or model of cable converter or satellite service that you would like to control, then you’ll need to perform the following steps to unlock the ID Lock, enter a new manufacturer’s code, and lock the ID Lock again.

1.Turn on the cable converter.

2.On the remote control, press CBL once; it will blink once. Then press and hold SETUP until

the CBL key blinks twice.

3.Enter 9 8 2. The CBL key will blink four

times, indicating ID Lock is unlocked.

www.urcsupport.com/atlasocap

17