Universal Electronics OCAP 5 manual RE-ASSIGNING Device Keys, Write those settings

Atlas OCAP M1056.fm Page 21 Wednesday, April 30, 2008 2:52 PM

4.Press and hold SETUP until the CBL key blinks twice.

RE-ASSIGNING DEVICE KEYS

The Atlas OCAP 5-Device Remote Control can be set up to control a second device of an already-assigned type. For example, to have the unit control a TV, a Cable Converter, and two audio devices (for example, two audio receivers), re-assign the unused VCR key to operate the second audio device as follows:

NOTE:	VCR is preset at the factory to control an RCA
	VCR. Performing the steps below will over-
	write those settings.

1.On the remote control, press VCR once; it will blink once. Then press and hold SETUP until

the VCR key blinks twice.

2.Enter 9 9 2. The VCR key will blink twice.

3.Press AUD once, then press VCR once. The VCR

key will blink twice.

The VCR key is now ready to be programmed for your second audio device. See “Programming Device Control” on page 10. To re-assign other device keys, repeat these and substitute the key sequence using the following chart:

NOTE: Only one device can be assigned to an unused device key at a time.

To Re-Assign Perform Key Sequence

VCR as 2nd VCRÆSETUPÆ9Æ9Æ2ÆAUDÆVCR AUD key

VCR as 2nd VCRÆSETUPÆ9Æ9Æ2ÆTVÆVCR TV key

VCR as 2nd VCRÆSETUPÆ9Æ9Æ2ÆCBLÆVCR CBL key

VCR back to VCRÆSETUPÆ9Æ9Æ2ÆVCRÆVCR VCR

www.urcsupport.com/atlasocap

21