Universal Remote Control R6 AUX Function Programming 6th Component, Component Buttons Select Info

AUX Function: Programming

a 6th Component

After you’ve finished programming the AVEX R6 for five primary components and you did not use AUX, you can take advantage of the AUX function to pro- gram a 6th component, such as a second TV, DVD, or any other audio/video component that you may have in your system.

Finding a Component’s Set-up Code Number

If you used the Auto--Search or Learning Methods to program a component, you may not know the code number you programmed. Here is a way for you to identify what that code number is, so you can make a note in the back of this Manual for future reference.

STEP 1: Press the component button you would like to verify and the SELECT [SEL] button at the same time for 2 seconds until the selected component LED light turns on.

IMPORTANT: You have 30 seconds to perform the next step while you are in programming mode. If you do not press a button within 30 seconds, the component LED light will turn off. The remote will exit the programming mode and you will have to start over.

COMPONENT

BUTTONS

SELECT

INFO

STEP 2: Press the INFO button and count the number of times the Component LED light blinks. This number indicates the first digit of the code. Next it will pause for about one second and begin blinking again to indicate the number of the second digit. Then once again it will pause, then blink,

o indicate the number of the third digit.

Example: One blink, pause, eight blinks, pause, three blinks indicates code number 183.

Note that ten (10) blinks represent the number 0.

Page 16