Univex 5.4 manual How The Remote Communicates, Programming For Other Equipment

If you program the remote to control other equipment, refer to the following pages located at the beginning of this guide for remote control operation instructions:

•TVs, Remote Operation TV Mode, page S-5.

•VCRs and DVD players, Remote Operation VCR Mode, page S-6.

•DISH Network satellite receivers, Remote Operation SAT Mode, page S-4.

•Stereo equipment use only these buttons: SELECT (change inputs), MUTE, VOLUME, and POWER.

HOW THE REMOTE COMMUNICATES

This remote uses IR signals to control the receiver and other equipment.

IR signals travel only short distances (up to 40 feet), and cannot go through walls or other solid objects. Point the remote control right at the equipment you want to control, with no objects to block the signal path.

PROGRAMMING FOR OTHER EQUIPMENT

Page S-2,Program the Remote to Control Your TV, shows you how to program the remote to control a TV. This section uses a different method to program the remote to control a TV or other equipment (such as a VCR, DVD player, tuner, amplifier, or a second TV). You can program the remote by either following the instructions in Programming Using Equipment Code Tables on page 4, or the Scanning for Equipment Codes procedure described on page 5.

COMBINATION EQUIPMENT (FOR EXAMPLE, TV/VCR)

When programming the remote to control combination equipment, such as a TV/VCR or a TV/DVD, program the remote control in one mode, and then repeat the procedure in the other mode. Use the appropriate equipment codes provided later in this guide (see page 12). For example, to program the remote to control a Magnavox TV/VCR using code 887, follow the instructions to program the remote to control the TV using code 887, and then repeat the instructions for the VCR using code 797. Put the remote in TV mode to use the TV and VCR mode to use the VCR.

2