Univex 5.4 manual Programming The Remote To Control A Second Receiver In Aux Mode

PROGRAMMING THE REMOTE TO CONTROL A SECOND RECEIVER IN AUX MODE

If you have another DISH Network satellite receiver installed, you can use this remote in AUX mode to control it along with your new receiver. When you program the remote to control the other receiver, the remote sends out IR signals to the receiver. You can program the remote to control any other DISH Network satellite receiver, except for following:

•TV2 on Duo 322 (also known as DISH 322), DuoDVR™ 522, DuoDVR™ 625, DuoDVR™ ViP® 222, and DuoDVR™ ViP® 622 (also known as DISH Player-DVR models 522, 625, and ViP 222, & ViP 622 DVR)

•DishPlayer 7100/7200

1Turn on the other receiver and display the System Info screen (see the receiver’s User Guide for information on how to display this screen).

Write down the address shown:

2Press and hold the AUX button until all the other mode buttons light up, and then let go of the button. The AUX button flashes.

3Press the 3 button.

4Use the NUMBER PAD to enter the address you wrote in step 1.

5Press POUND (#). The AUX button blinks three times.

6Press RECORD to make sure the address and the remote matches the address on the receiver.

8