Univex 5.4 manual Troubleshooting, Remote to Control Your TV on, page S-2 and Programming for

TROUBLESHOOTING

What’s	What’s Wrong	What You Can Do
Happening
While doing	• If you don’t	Start over again.
remote	press
control	a button for 20
procedure,	seconds in a
the remote	programming
control stops	sequence, the
working.	remote shuts off
	its programming
	function.
When you	• Maybe you	• Press the correct mode button to
press a button	didn’t set the	set the remote to the mode for the
on the remote	remote to the	equipment you want to control.
control, the	mode for the
equipment	equipment you
doesn’t do	want to control.
what you
expect.	• Maybe you’re	• The remote control uses IR signals
	not pointing the
		to control all equipment except for
	remote control
		the receiver (when using UHF). IR
	right at the TV
		signals travel only 40 feet or less,
	(or other
		and can’t go through walls or other
	equipment).
		solid objects. You must point the
		remote control right at the
		equipment, with no objects to
		block the signal path.
	• Maybe the	• If the batteries are missing or dead,
	remote control is
		put fresh AAA-size batteries in. If
	missing
		the remote has fresh batteries,
	batteries, maybe
		check whether you put them in the
	you put the
		right way. If you didn’t, take them
	batteries in the
		out and put them in the right way.
	remote the
	wrong way, or
	maybe the
	batteries are
	weak or dead.
	• Maybe you	• Make sure you set up the remote
	didn’t set up the
		to control all the equipment you
	remote to
		want to use. See Program the
	control the
		Remote to Control Your TV on
	equipment.
		page S-2 and Programming for
		Other Equipment on page 2.

20