Univex 5.4 manual Programming Using Equipment Code Tables, Instructions, Additional Information

PROGRAMMING USING EQUIPMENT CODE TABLES

You can set up the remote to control other equipment using the equipment codes listed on page 12 and the modes as shown on page 1.

	Instructions	Additional Information
1	Turn the equipment on.	Use the equipment’s front panel
		buttons or its remote control.
2	Find the brand name of the	If the brand isn’t listed, see
	equipment in the tables	Scanning for Equipment Codes
	starting on page 12.	on page 5.
3	Press and hold the mode	For example, hold the TV mode
	button until all the other	button for a TV until all of the
	mode buttons light up, and	other mode buttons light. When
	then let go of the button.	you let go, TV flashes.
	The mode button flashes.

4For AUX mode only. Press 0 for a second TV, or 1 for a second VCR, or 2 for a tuner or amplifier.

5Enter one of the three-digit equipment codes from the table using the number buttons.

6If you want to program Limited Mode, press 1. If not, skip to step 7.

7Press POUND (#).

This step is for programming the kind of equipment that should be programmed in AUX mode. If you’re not programming in AUX mode, skip to step 5.

The three-digit equipment code should be for the brand name of your equipment that you found in step 2.

See Limited Mode on page 3 for more information.

If you entered the code correctly, the mode button flashes three times.

8Press POWER to turn off the equipment. If the equipment does not turn off, go to step 10.

If the code works, the equipment turns off.

4