OWNER’S MANUAL
TROUBLESHOOTING
Continued
OBSERVED PROBLEM | POSSIBLE CAUSE | REMEDY | ||
Burner does not light after ODS/pilot is lit | 1. | Burner orifice is clogged | 1. | Clean burner (see Cleaning and Mainte- |
|
|
|
| nance, page 23) or replace burner orifice |
| 2. | Burner orifice diameter is too small | 2. | Replace burner orifice |
| 3. | Inlet gas pressure is too low | 3. | Contact local natural gas company |
|
|
|
|
|
Delayed ignition of burner | 1. | Manifold pressure is too low | 1. | Contact local natural gas company |
| 2. | Burner orifice is clogged | 2. | Clean burner (see Cleaning and Mainte- |
|
|
|
| nance, page 23) or replace burner orifice |
|
|
|
|
|
Burner backfiring during combustion | 1. | Burner orifice is clogged or damaged | 1. | Clean burner (see Cleaning and Mainte- |
|
|
|
| nance, page 23) or replace burner orifice |
| 2. | Burner damaged | 2. | Replace burner pressure |
| 3. | Low inlet gas pressure | 3. | Contact local natural gas company |
| 4. | Gas regulator defective | 4. | Replace gas regulator |
|
|
|
|
|
Slight smoke or odor during initial operation | 1. | Residues from manufacturing processes | 1. | Problem will stop after a few hours of |
|
|
|
| operation |
|
|
|
|
|
Fireplace produces a whistling noise when | 1. | Air in gas line | 1. | Operate burner until air is removed from |
burner is lit |
|
|
| line. Have gas line checked by local |
|
|
|
| natural gas company |
| 2. | Air passageways on fireplace blocked | 2. Observe minimum installation clearances | |
|
|
|
| (see pages 8 through 10) |
| 3. | Dirty or partially clogged burner orifice | 3. | Clean burner (see Cleaning and Mainte- |
|
|
|
| nance, page 23) or replace burner orifice |
White powder residue forming within burner box or on adjacent walls or furniture
1.When heated, vapors from furniture pol- ish, wax, carpet cleaners, etc. turn into white powder residue
1.Turn heater off when using furniture polish, wax, carpet cleaners, or similar products
www.desatech.com | Continued |
107031 | 21 |
