5.2. Crosspoint Gain
Set the crosspoint switch gain. 9000Series Amplifier responds with the same data as that received. This command is enabled when in the mixer mode only.
Note: Command cannot be received during power off.
95H, 05H, <Source Channel Attribute>, <Source Channel Number>, <Destination Channel Attribute>, <Destination Channel Number>, <Value>
<Source Channel Attribute> 00H: Input channel
<Source Channel Number> 00H - 07H (Input channel 1 - 8)
<Destination Channel Attribute> 01H: Output channel
<Destination Channel Number> 00H – 07H (Output channel 1 - 8)
<Value>
00 - 51H: Gain Position
60 - 6FH: Position Down (1 – 16dB Step Down)
70 - 7FH: Position Up (1 – 16dB Step Up)
Example 1: Setting the crosspoint gain from Input Channel 1 to Output Channel 1 to a fixed value of 0 dB
95H, 05H, 00H, 00H, 01H, 00H, 47H
Example 2: Increasing the crosspoint gain from Input Channel 1 to Output Channel 1 by +3.0 dB steps
95H, 05H, 00H, 00H, 01H, 00H, 72H
See Crosspoint Gain Table on the next page.
Page 9 of 24
