VBrick Systems EtherneTV-NXG 1 manual Verify EtherneTV-NXG Server Operation, Verify entries

V B R I C K E T H E R N E T - N X G V O D Q U I C K S T A R T G U I D E V E R S I O N 2 . 0 . 0 E

Verify entries

The previous entries will be displayed.

•Review the information you entered. If everything appears to be correct, type “y” and Enter to continue. Otherwise, type “n” and repeat the setup process.

•The EtherneTV-NXG server displays the configuration files it will update. Type “y” then press Enter to continue. The changes will be displayed for each of the following files. Review each, type “y” to accept, then press Enter to continue.

o /etc/sysconfig/network

o /etc/sysconfig/network-scripts o /etc/resolve.conf

o ServerName in httpd.conf

•When asked if you have completed reviewing the files to be updated, type “y” then press Enter to continue.

•Wait several minutes for setup to complete. A message will be displayed:

Done

Omnibase setup is complete; press enter to continue to login

•Press Enter

•Enter the login and password when prompted:

At the login prompt, type “root” then press Enter.

At the password prompt, type “omnibase” then press Enter.

•NOTE: If you encounter an error during set-up or if the server is moved to another network you MUST perform the following operation:

Rename the setup file as follows:

￿root# mv /opt/vbricksetup/.vbrickmbase_is_setup /opt/vbricksetup/.vbrickmbase_is_not_setup

Reboot the server

root# reboot

4. Verify EtherneTV-NXG Server Operation

Verify that there is an amber link light on the EtherneTV-NXG server’s Ethernet port.

•From the Linux Administrator command line: Ping the local gateway IP address.

Example: ping 172.17.1.5 (use your appropriate local gateway IP address)

•From a separate PC: Ping the EtherneTV-NXG server from a PC using the EtherneTV-NXG1 IP address.

Example: ping 172.17.6.55 (use the IP address of your EtherneTV-NXG server)

C O P Y R I G H T V B R I C K S Y S T E M S P A G E 8 J U N E 2 3 , 2 0 0 4