Vector VEC051D owner manual Permanent Installation, Connection To Load, Operating Tips

90548013 VEC051D INVERTER.qxp 3/6/09 10:31 AM Page 9

Permanent Installation

The permanent installation of the inverter and the required wiring and safety devices to the 12 Volt DC power source must be performed by a professional installer. Further requirements are:

1.The inverter is supplied with 4 Special Crimp Connectors to connect the power source wiring to the inverter DC input terminals. They are designed to be crimped onto #2AWG copper conductor cables (not supplied).

2.The #2AWG power source cables must not exceed 6 feet in length.

3.A 400 Amp ANL Fuse (not supplied) installed in the proper Fuse Holder (not supplied) must be connected in- line as part of the positive power source input cable as close as possible to the power source connections.

4.A #12AWG insulated wire should be connected between the Grounding Terminal on the inverter (see “Controls and Functions”, “Back View Diagram” on page 4 ) and the ground terminal on the appliance (such as a TV or Radio) to minimize electrical noise and reception interference.

CAUTION: Do not connect this wire to the inverter’s Negative (Black, -) DC input terminals.

CAUTION: Violation of these requirements may result in unsafe operation and/or equipment failure. Damage to the inverter as a result of improper installation voids the warranty.

The DC power source must be a well-regulated DC power supply as typically found in vehicle and deep-cycle marine batteries. The DC power source may also be two 12 volt batteries connected in parallel. On larger applications the power source may be several batteries connected in parallel as shown in the following “Permanent Battery Configuration” diagram.

Permanent Battery Configuration Diagram

	BATTERY CHARGING			FUSE TO BATTERY LENGTH
				+ FUSE TO INVERTER LENGTH
	FROM COMMERCIAL
AC, ENGINE, SOLAR, ETC.					(MAX FEET OF
					AWG WIRE)
				(See the “Specifications” section)
		BATTERY	FUSE HOLDER
				ANL FUSE
							MAXX SST™
							POWER
		BATTERY
							INVERTER
					(MAX FEET	OF
		BATTERY
					AWG WIRE)
			(See the “Specifications” section)
		BATTERY

Note: For typical heavy-duty uses in a Permanent Installation, an ANL fuse must be added as close as possible to the power source (battery) positive terminal. The fuse amperage size must be appropriate to allow simultaneous operation of all the AC appliances to be powered, with delay characteristics that allow for the momentary high start-up current requirements of inductive loads. Use the specified fuse block (fuse holder) and fuse. For full rated output and motor start-up surge output, ensure that the installation is configured to handle the full load. See the “Permanent Installation” section of this Instruction Manual.

Connection To Load

The Power Inverter is equipped with standard North American three-prong type outlets. Plug the cord from the equipment you wish to operate into the AC outlet(s). Make sure the combined load requirement of your equipment does not exceed maximum continuous power.

The Power Inverter is engineered to be connected directly to standard electrical and electronic equipment in the manner described above. Do not connect the Power Inverter to household or RV AC distribution wiring. Do not connect the Power Inverter to any AC load circuit in which the neutral conductor is connected to ground (earth) or to the negative of the DC (battery) source.

WARNING: TO REDUCE THE RISK OF ELECTRIC SHOCK, PROPERTY DAMAGE OR PERSONAL INJURY: Never connect unit directly to AC distribution wiring.

Operating Tips

For best operating results, the inverter should be placed on a stable, flat surface. The inverter should only be used in locations that meet the following criteria:

DRY — Do not allow water or other liquids to come into contact with the inverter.

COOL — Surrounding air temperature should be between –0°C and 40°C — ideally between 15°C and 25°C (60-80°F). Keep the inverter away from direct sunlight, when possible.

9