ACCESSORIES
Please Check and Identify the Included Accessories.
Remote control | x 1 |
AAA 1.5V battery | x 2 |
Mounting template | x 1 |
1.06" (27mm) spacers | x 4 |
.57" (14.4mm) spacers | x 4 |
.32" (8.2mm) spacers | x 4 |
#M 5 x 69 mm screws | x 4 |
#M 5 x 40 mm screws | x 4 |
FM wire antenna | x 1 |
AM LOOP antenna | x 1 |
REMOTE CONTROL
Using the Remote Control
•This remote control is magnetic and can be attached to most refrigerators. Some refrigerators panels are not metallic. In this case, try attaching the magnetic remote control to the side of the refrigerator.
•Point the remote control at the REMOTE SENSOR located on the unit.
•When there is a strong ambient light source, the performance of the infrared REMOTE SENSOR may be degraded, causing unreliable operation.
•The recommended effective distance for remote operation is about 16 feet (5 meters).
To Install Batteries
1.Open the battery door.
2.Insert two AAA batteries.
Battery Replacement
When the batteries become weak, the operating distance of the remote control is greatly reduced and you will need to replace them.
Caution: Danger of explosion if battery is incorrectly replaced. Replace only with the same or equivalent type.
Notes:
•Do not place the remote control near magnetic devices or magnetic cards.
•If the remote control is not going to be used for a long time, remove the batteries to avoid corrosion damage caused by battery leakage.
•Do not mix old and new batteries. Do not mix ALKALINE, standard
•Always remove batteries as soon as they become weak.
•Batteries shall not be exposed to excessive heat such as sunshine, fire or the like.
•Weak batteries can leak and severely damage the remote control.
•WARNING: Do not dispose of batteries in a fire. Batteries may explode or leak.
CAUTION: When discarding batteries, environmental problems must be considered and local rules or laws governing the disposal of these batteries must be strictly followed.
- 6 -
