Vermont Casting 2490 Unprotected Surfaces, Protected Surfaces, Resolute Acclaim Woodburning Stove

Resolute Acclaim Woodburning Stove

Distance from the Center of the Flue Collar to the Wall in Top-Exit Installations

The information on this page is helpful in planning stove placement for top-exiting installations, particularly those in- stallations with chimneys that pass through the ceiling. However, this is not a clearance chart. Final stove clearances must adhere to the guidelines stated in the Clearance Chart on Page 8.

Resolute Acclaim: WITHOUT Stove and Chimney Connector Heat Shields

	Unprotected Surfaces				Protected Surfaces
			Corner				Corner
Parallel Installations			Installations**	Parallel Installations			Installations**
Side (A)		Rear (B)	Corner (C)	Side (D)		Rear (E)	Corner (F)
27¹⁄₂”		26”	25¹⁄₂”	20¹⁄₂”		15”	18¹⁄₂”
(699 mm)		(660 mm)	(648 mm)	(521 mm)		(381 mm)	(470 mm)

A	B	C	D	E	F
	*		*
					ST608

*This distance, from the center of the flue collar to the front edge of the hearth, is the same for all installations on this page: 35” in the United States and 37” (940mm) in Canada.

Resolute Acclaim: WITH Stove and Chimney Connector Heat Shields

	Unprotected Surfaces				Protected Surfaces
			Corner				Corner
Parallel Installations			Installations**	Parallel Installations			Installations**
Side (A)		Rear (B)	Corner (C)	Side (D)		Rear (E)	Corner (F)
27¹⁄₂”		17”	25¹⁄₂”	20¹⁄₂”		11”	18¹⁄₂”
(699 mm)		(432 mm)	(648 mm)	(521 mm)		(279 mm)	(470 mm)

A	B	C	D	E	F
					ST608a

**To locate center of flue collar for corner installation, add 10¹⁄₂” (270mm) to the clearance distance from stove corner to wall. Mark off the resulting distance from the corner along both walls. Next, measure the same distance from these two points out from the walls. These last two measurements will meet at a point representing the center of the flue collar. Refer to the dia- grams above.

2000893 15