Vermont Castings UVS27
Right
Side
Wingbolt
ST105
Fig. Secure right side to the back panel.
5.Lift the firebox assembly as a unit and slide it back to position it within the shell. The base of the firebox should rest on the side support shelves as in Figures 7 and 9. The side plates interlock with the firebox by use of a pair of steel tabs that engage with the ribs on the base of the firebox. (Fig. 9) Properly posi- tioned, the firebox will be level and locked in place. If not, adjust the levelling screws as required to keep the entire assembly level.
Steel Tab
Side Plate
Screw & Washer
Back Panel
Side
Plate 
Support Shelf
ST106
ST125
Fig. 9 Install the firebox assembly,. Be sure steel tabs engage ribs on base of firebox.
Install Optional Fan Kit
1. | Attach the fan to the firebox by engaging the upper |
| flange of the fan skirt under the lower edge of the |
| shroud and secure the skirt with the four screws and |
| one star washer provided. (Fig. 10, 11) |
2. | Feed the snapstat wire lead up between the inner |
| and outer rear shroud panels and secure the |
| snapstat to the upper right side of the inner shroud. |
| (Fig. 12) |
Fig. 7 The sides must be at right angles to the back panel in order for the firebox to fit properly.
4.Connect the gas supply line to the burner control valve before you install the firebox. This may be a flexible line, (not supplied), or hard plumbing.
1/2” Gas Supply
1/2” NPT x 1/2” Flare Shutoff
Valve
3/8” Flex Line
(from Valve)
FP297a
Fig. 8 Typical gas supply installation.
3. | Secure the snapstat wire harness to the shroud |
| panel using the wire tie provided. |
4. | Route the rheostat control switch and wire forward |
| under the stove. Use the wire tie to secure the fan |
| and rheostat wire harnesses together to the tubing |
| under the bottom heat shield. |
5. | Install the rheostat onto the bracket to the left of the |
| valve. (Fig. 13) |
10 | 20005004 |
