Complete the Installation

Vermont Castings UVS27 Vent-Free Gas Heater

Complete the Installation

1.Install the screen frame by sliding the hooks over the top front edge of the firebox and resting the bottom on the support brackets. If the catalyst has been installed, place the glass front on the stove by resting the bottom edge of the frame on support brackets below the front opening of the firebox. Rotate the top edge of the assembly toward the firebox, and center it. Rotate the right and left cams towards the back of the firebox to secure glass frame in place.

2.Grasp the front plate by the window bars and lift into position engaging the two steel tabs behind the adjacent bosses in the side plates. (Fig. 25) then seat the front against the sides so the tabs at the bottom lip engage with the notches in the stove legs.

Engage steel tabs behind the cast iron bosses

Control Door

Bottom Tabs engage notch in the leg.

ST112

Fig. 25 Install the Front Plate. Your Front may look different from that shown.

On the Pinnacle, the front tabs will engage behind the notched cutouts in the base of either side plate. (Fig. 26)

When properly installed, the bottom of the front plate cannot be pulled away form the sides without lifting it.

NOTE: Be sure that the control door can swing out. It should close against the steel tab stop.

If installing the optional warming shelf, you may find it easiest to attach it to the top plate before placing the top in position on the stove. Follow the instructions supplied with the kit.

 

Bottom Tabs engage notch

ST113

in the base.

Fig. 26 Engage the Hearthmount Front with the notch in the bse of each side plate.

3.Tilt the top plate to engage its rear rib in front of the back panel, then carefully lower it onto the sides. (Fig. 27) The upper edge of the side plates should seat into the channel in the underside of the top.

4.Lay the screen and top grille in place.

This completes assembly of the Stardance Freestand- ing and Pinnacle Hearthmount shells.

Grille

Screen

Manual background Top Plate

Levelling

Screws

ST114

Fig. 27 Install the Top Plate and Grille.

20005004

15

Page 15
Image 15
Vermont Casting 3032, 3033, 3030, 3031 manual Complete the Installation, Vermont Castings UVS27 Vent-FreeGas Heater, 20005004