Chateau™
Fuel Conversion Instructions
WARNING! This conversion kit shall be installed by a qualified service agency in accordance with the manufacturerʼs instructions and all applicable codes and requirements of the authority having jurisdiction. If the information in these instructions is not followed exactly, a fire, explosion or pro- duction of carbon monoxide may result causing property damage, personal injury or loss of life. The qualified service agency is responsible for the proper installation of this kit. The installation is not proper and complete until the operation of the converted appliance is checked as specified in the manufacturerʼs instructions supplied with the kit.
CAUTION: The gas supply shall be shut off prior to disconnecting the electrical power, before pro- ceeding with the conversion.
Avertissement: Cette trousse de conversion
Ne doit être installée que par le représentant dʼun organisme qualifié et conformément aux instruc- tions du fabricant et aux codes et exigences pertinentes de lʼautorité compétente. Quiconque ne respecte pas à la lettre les instrucitons du présent guide risque de déclencher un incendie, une explosion ou le dégagement de monoxyde de carbone entraînant des dommages matériels, des lésions corporelles ou la perte de vies humaines. Lʼorganisme qualifié qui effectur les travaux est responsible de lʼinstallation de cette trousse. Lʼinstallation nʼest pas terminée tant que le fonc- tionnement de lʼappareil converti nʼa pas été vérifié selon la notice du fabricant qui accompagne la trousse.
ATTENTION: Avant dʼeffectuer la conversin, coupez dʼabord lʼlimentation en gaz, ensuite, coupez lʼalimentation électrique.
Conversion Precautions
Allow unit to cool if it has been operating.
Before proceeding with conversion, turn control knob on valve to OFF and turn gas supply OFF. Turn OFF any electricity that may be going to appliance.
Conversion Procedure
1.Remove glass frame. Refer to Glass Frame Assembly section on Page 20.
2.Remove lava rock, volcanic rock, embers and logs.
CAUTION: Logs may be hot.
3.With a Phillips or Robertson screwdriver, remove the two (2) screws holding the fettle to the burner assem- blies. With a hex, remove the two (2) hex nuts holding
the burner tube to the front of the burner assembly. Remove burner tube.
4.Remove two (2) hex nuts holding the left burner leg. Remove burner leg. (Fig. 53)
| KT416 |
Fig. 53 | Use 3/8” socket to remove hex nuts holding left burner |
leg. |
|
5.Slide the burner housing assembly to the left and away.
6.Replace the three (3) injectors. Refer to Table 1.
7.Replace pilot orifice.
8.Remove pilot hood by lifting up. (Fig. 54) NOTE: It is not necessary to remove the pilot tube for conversion.
9.Remove pilot orifice with 5/32” Allen wrench. (Fig. 55)
Pilot Hood |
Pilot |
Bracket |
CO105a |
Fig. 54 Remove pilot hood. |
Index Tab | Allen Wrench |
Snap Ring |
|
| CO106a |
Fig. 55 Remove pilot orifice. |
|
20006081 | 29 |
