Vermont Casting Encore NC 1450 Fan Kit Installation, Encore 1450 Non-CatalyticWoodburning Stove

Encore 1450 Non-Catalytic Woodburning Stove

Fan Kit Installation

1.Remove the sheet metal outer back shown in Figure 32.

2.Attach the fan assembly at the bottom edge of the in- ner back with two (2) 1/4-20 x 3/4” hex head screws and one (1) 1/4” star washer.

3.Attach snapstat to the mounting holes on the un- derside of the bottom with two (2) 1/4-20 pan head screws.

4.Attach the rheostat holder, (provided with stove), under the right wing of the bottom heat shield with two (2) #10 sheet metal screws.

5.Attach the rheostat to its holder by inserting the rheostat control shaft through the holder hole. Install the retaining ring and rheostat onto the shaft.

6.Secure the rheostat cable to the underside of the bottom heat shield using the wire tie provided on the hole at the right rear edge of the heat shield.

7.Fan will not operate until stove reaches approximate- ly 109°F.

8.Replace the sheet metal outer back.

Rheostat

Knob

Rheostat

Snapstat Screws

Fig. 32 Fan installation (Kit # 2767).

ST848

20 30002425