Vermont Casting Gas Grill Assembly - Mount the Side Burner Knob, Phillips head screwdriver, Valve

Assembly Step 6 - Mount the Side Burner Knob

Tools Needed:

Phillips head screwdriver

USE HARDWARE PACK E :

M4x0.7x8mm

BurnerBolt (1)

Control

Knob

M5x0.7x8mm

Bolt (1)

Match Holder

and Chain

Burner Control Valve

Burner	Valve
Tube	Orifice

1.Working underneath the Side Burner Assembly, locate and remove the two bolts that are holding the brass burner to the side table. This will allow the burner tube to hang and move freely.

2.Locate the burner control valve attached to the end of the gas hose hanging from the side of the Grill Head Assembly.

3.Insert the orifice of the control valve into the end of the burner tube.

4.Route the control valve stem through the mounting hole in the side table.

5.Re-insert and securely tighten the burner mounting bolts that were removed in step 1 above.

IMPORTANT: The valve orifice must be seated inside the burner tube for safe operation. An improperly seated valve-to- burner tube connection may result in an external fire causing property damage or serious personal injury.

15