Vermont Casting IRFSDV34 Operating Instructions, General Glass Information, Window Frame Removal

Irving Oil

OPERATING INSTRUCTIONS

GENERAL GLASS INFORMATION

Only glass approved by the Vermont Castings, Majestic Products Company may be used for replacement.

•The use of substitute glass will void all pro- duct warranties.

•Care must be taken to avoid breakage of the glass.

Under no circumstances should this fireplace be operated without the front glass or with a broken glass. Replacement of the glass (with gasket) as supplied by the manufacturer should be done by a licensed qualified service person.

INSTALLATION OF LOGS & BURNER

LAVA ROCK MATERIAL

Model: IRFSDV34

Refer Figure 32.

1.Remove window frame assembly (See “Window Frame Assembly” section).

2.Remove logs from packaging.

As with all plastic - these are not toys and should be kept away from children and infants.

WINDOW FRAME REMOVAL

1.Shut off gas (See Lighting Instructions).

2.Let the unit cool if it has been operating.

3.Open two side doors

4.Open the clamps on two sides.

5.Pull the frame forward.

6.To reinstall window frame assembly follow the above procedure in reverse.

Release clips (2 per side)

Fig. 31

GLASS CLEANING

It will be necessary to clean the glass periodically. During start-up condensation, which is normal, forms on the inside of the glass. This condensation causes lint, dust and other airborne particles to cling to the glass surface. Also initial paint curing may deposit a slight film on the glass. It is therefore recommended that the glass be cleaned two or three times with a non-ammonia based household cleaner and warm water (We recommend gas fireplace glass cleaner). After the initial cleaning process the glass should be cleaned two or three times during each operating season depending on the environment.

Clean glass after first two weeks of operation.

3.Place rear log (KR10) on rear bracket (ensure log is seated properly, leveled and centered to the unit), so it will not move from side to side and it is firmly positioned on the bracket.

4.Slip front ember log (KR7) down behind the front deflector.

5.Place front left log (KR8) on top of burner, left side. Use log’s bottom holes to locate it into the left bracket log locator studs.

6.Place front right log (KR9) on top of burner, right side. Use log’s bottom holes to locate it into the right bracket log locator studs.

7.Place burner lava rock on top of burner between the ember log and the two front logs.

8.Place top left log (KR11) onto locator notches. Ensure log is secure.

9.Place top right log (KR12) onto locator notches. Ensure log is secure.

KR11	KR12
	KR10
KR8	KR9

KR7 Fig. 32

18 10004000