Vermont Casting 3358 Complete the Installation, Radiance Vent-FreeGas Heater, 20004555, Top View

Right Log

Right Rear Log

Left Rear Log

Left Bracket	Decorative	Right Bracket
	Grate
LG171

Fig. 23 Install the left and right rear logs and the right log.

Log rests on	Lava Rock
decorative grate
		LG172

Fig. 24 Completed log installation.

5.Loosely sprinkle the lava rocks directly on top of the burner just behind decorative grate. (Fig. 25) Use the lava rock to cover brackets on the burner. Do not place lava rocks toward back of burner. The lava rock is shipped inside the bag assembly.

Left Rear Log	Top View	Right Rear
		Log

Decorative Grate	Lava rock may
	be placed in this
LG160	area

Fig. 25 Lava rock placement.

Radiance Vent-Free Gas Heater

Complete the Installation

1.Replace the screen frame by sliding the hooks over the top front edge of the firebox and resting the bot- tom on the support brackets. If the catalyst has been installed, place the glass front on the stove by rest- ing the bottom edge of the frame on support brack- ets below the front opening of the firebox. Swing the top edge of the assembly toward the firebox, and center it. Fasten it by closing the latches over the top left and right edges of the frame.

2.Replace the stove front by grasping it by the left and right edges. Lift it so that tabs on the back side of the top corners engage notches at the top forward corners of the stove sides. Then gently swing the bottom of the front panel to a vertical position, and lower it till prongs on its bottom left and right corners engage with notches cast into the tops of the forward legs. (Fig. 26) Test that the front is installed securely by grasping two of panel’s vertical bars, and pulling the panel toward yourself. When the panel is in place properly you should not be able to pull the bottom of the front toward yourself without also lifting it.

3.Attach the wooden handle to the control door using the #8-32 x 2” screw from the parts bag. (Fig. 27)

4.Set the screen and the cast-iron grate into the re- cess in the stove top.

This completes the installation and assembly of the Radiance RUVSOD.

ST139a

Fig. 26 Replace the front panel.

ST197

Fig. 27 Attach the handle to the control door.

20004555 15