Radiance
Assemble the Legs
1.Slide stove to the rear of the pallet just far enough to access rear leg holes. Make sure the stove does not tip over backwards. (Fig. 7)
ST720
Fig. 7 Slide stove back just far enough to access rear leg holes.
2.Attach the rear legs using 3/8” hex head bolts and flat washer supplied. Tighten with a 9/16” wrench or socket.
3.Carefully tip the stove onto its rear legs. Adjust the pallet to allow access to one of the front leg holes. Be sure to leave the pallet under the stove to prevent the stove from falling fully forward. (Fig. 8)
CAUTION: To prevent valve tubing from being crushed or damaged, make sure to rest valve on wooden pallet.
| Washer |
ST721 | Hex Head Bolt |
Fig. 8 Carefully tip stove onto back legs. Leave pallet under stove to keep stove from falling fully forward.
4.Have your assistant attach one leg using the hard- ware described.
5.Move the pallet to allow access to the other front leg hole. Attach remaining leg.
6.Remove pallet and allow stove to gently rest on all four legs.
7.Adjust leg levelers to compensate for irregularities in the hearth.
Install Optional Fan
It is easiest to install the optional fan kit #2767/FK26, before the stove is moved to its final location or con- nected to the gas line.
The fan consists of a blower assembly and a rheo- stat switch that are connected by a wire harness. The blower attaches to a bracket at the bottom of the rear shroud. The rheostat installs at the bottom of the stove on the left of the valve.
The fan kit includes a ‘snapstat’, a
The rheostat provides a range of fan speed settings from OFF (which overrides the snapstat function) to high.
Kit Contents
• Fan assembly with rheostat and snapstat
• wire tie | • control knob • retaining collar |
CAUTION: Sheet metal edges can be sharp. Be sure to wear protective gloves.
1.Loosen the four phillips head screws which secure the rear shroud to the stove sides. (Fig. 9)
2.Carefully pull the shroud assembly away from the rear of the stove.
3.With the rear shroud assembly in the upright posi- tion, set the bottom of the shroud on a padded surface to prevent scratching the surface. Unfasten the four phillips head screws which attach the outer shroud to the inner duct assembly.
Rear Shroud As- sembly
ST189
Fig. 9 Loosen four phillips screws holding rear shroud as- sembly and remove. Remove four phillips screws holding rear shroud to inner duct assembly. Remove rear shroud.
10 | 20004555 |