Vertex Standard FT-2800M Labeling Memories, DWN, DWN, MHz, SET, MHz, SET, REV, MHz, SET, D/MR, DIAL, DIAL, DIAL, DIAL, MH-48, D/ MR, 00 ALPH, MEMORY RECALL, Press the, Press the

MEMORY OPERATION

MEMORY RECALL

Once you have stored the memory or memories desired, you must now switch from the “VFO” mode to the “Memory Recall” mode, so you can operate on the just-stored memory channels.

1.Press the [D/MR(MW)] key, repeatedly if necessary, until the “MR” icon and a memory channel number appear on the display; this indi-

cates that the “Memory Recall” mode is now en- gaged. 2. When more than one memory has been stored, use

the DIAL knob to select any pf the programmed memories for operation. Alternatively, the microphone’s [UP] or [DWN] button may be used to step or scan through the available memories. When using the microphone’s buttons, press the button momentarily to move one step up or down; press and hold in the [UP] or [DWN] button for one second to begin memory scanning.

Memory Recall from the Microphone’s Keypad:

While operating in the Memory Recall mode, the keypad of the MH-48A6JMicrophone may be used for direct recall of memory channels.

To do this, press the Channel Number you wish to recall, then press the [Û] key. For ex- ample, to recall Memory Channel “5,” press [5] à [Û]. To recall Memory Channel “118,” press [1] à [1] à [8] à [Û].

Labeling Memories

You may wish to append an alpha-numeric “Tag” (label) to a memory or memories, to aid in recollection of the channel’s use (such as club name, etc.). This is easily accomplished using the Set (Menu) mode.

1.Recall the memory channel on which you wish to append a label.

2.Press and hold in the [MHz(SET)] key for one second, then rotate the DIAL knob to select “00 ALPH.”

3.Press the [MHz(SET)] key. You will notice the first character location blinking, indicat- ing that you are now in the Alpha-Numeric (“A/N”) entry mode. Within the A/N entry mode, rotate the DIAL knob to select characters; pressing the [REV(DW)] key will move the character’s entry location to the right.

4.Rotate the DIAL knob to select the desired number, letter, or symbol, then press the [D/ MR(MW)] key to move the next character’s location. Move two slots if you want to put in a space.

5.Repeat step 4, as necessary, to complete the name tag (up to six characters) for your memory, then press the [MHz(SET)] key momentarily to save the A/N name just entered.

6.Press and hold in the [MHz(SET)] key for one second to exit to normal operation.

FT-2800M OPERATING MANUAL 31