Vertex Standard FT-2800M MHz, SET, MHz, SET, REV, MHz, SET, DIAL, DIAL, DIAL, DTMF-1, DTMF-9, FT-2800M, FT-2800M, 10 DT MEM, 13 INTNET, engaged, Press the, Press and hold in the

INTERNET CONNECTION FEATURE

The FT-2800Mcan be used to access an Internet link on a repeater which is equipped for operation using the Vertex Standard WIRESTM (Wide-Coverage Internet Repeater Enhancement System) Internet linking system.

1.	Press the [ ] key to activate the Internet Connection feature. The “int” icon will appear
	in the memory channel field.
2.	Rotate the DIAL, while pressing and holding in the
	[ ] key, to select the access number correspond-
	ing to the WIRESTM repeater to which you wish to
	establish an Internet link (ask your repeater owner/operator if you don’t know the access
	numbers in the network).

3.With the Internet Connection feature activated (as in step 1 above), the FT-2800Mwill generate a brief (0.2 second) DTMF tone according to your selection in step 2. This DTMF tone is sent at the beginning of every transmission to establish or maintain the link to the remote WIRESTM repeater, while operating in the “SRG” (“Sister Repeater Group”) mode.

4.To disable the Internet Connection feature, press the [] key again.

For more information on WIRESTM, go online to http://www.yaesu.com/amateur/pdf/bro- chures/WIRES.pdf for an informative brochure. Or send an e-mail to WIRES@vxstdusa.com.

You may access other Internet Link Systems that use a DTMF string for access.

1.Press and hold in the [MHz(SET)] key for one second, then rotate the DIAL knob to select “10 DT MEM.”

2.Press the [MHz(SET)] key momentarily, then load the DTMF tones which you wish to use to establish an Internet link (the linking system’s Home Page should have this infor- mation) into the desired DTMF Memory channel.

1). Rotate the DIAL knob to select the DTMF Autodialer memory channel number (“DTMF-1” through “DTMF-9”).

2). Press the [D/MR(MW)] key momentarily.

3). Rotate the DIAL knob to select the DTMF code, then press the [REV(DW)] key momentarily to move the digit.

4). Repeat step 3) above as many times as needed to complete the access string.5). Press the [MHz(SET)] key momentarily to save the new setting.3.Rotate the DIAL knob to select “13 INTNET.”

4.Press the [MHz(SET)] key momentarily, then rotate the DIAL knob to set this item to “LINK” (to enable the alternate Internet Link, and disable the WIRESTM access option).

5.Press and hold in the [MHz(SET)] key for one second to save the new setting and exit to normal operation.

6.Press the [] key momentarily to activate the Internet Link System. The “int” icon will then appear in the memory channel field while the Internet Link System access feature is

engaged.

FT-2800M OPERATING MANUAL 41