Victory Refrigeration V-Series Section Installation, Receiving Shipment, Unpackaging Procedure

SECTION 2-INSTALLATION

SECTION 2-INSTALLATION

SECTION 2

INSTALLATION

IMPORTANT:

It is highly recommended that your

refrigerator or freezer be installed by an authorized Victory Certified Installer.

A. Receiving Shipment

Upon arrival, examine the exterior of the shipment packaging for any signs of rough handling.

If the cabinet is damaged, it should be noted on the delivery slip or bill of lading and signed to that effect. A claim must be filed immediately against the carrier indicating extent and estimated cost of damage incurred.

All units are performance tested and thoroughly inspected, prior to shipment. Upon leaving the factory, all units are in perfect condition and the carrier signs to this effect.

B. Unpackaging Procedure

4. Exercise extreme caution when removing the wooden skid especially when the last bolt is removed, as the skid, if not properly blocked, will fall to the floor with extreme force.

C. Reducing Refrigerator or Freezer Depth For Narrow Facility Doorway

In order to pass through a narrow doorway or restricted area, doors, front grill, hinges, and keeper may be removed to reduce the overall depth of the cabinet to a minimum or 31” deep.

1.Removing Doors

a.Open door to approximately 90°.

b.Lift door straight up and off hinges.

2.Front Air Grill

1.Split plastic wrap along one of the cardboard posts. Remove and discard all packaging material.

2.WARNING

Never, under any circumstances, lay your new refrigerator or freezer down on either it’s back, front or sides.

Laying the equipment down will allow compressor oil into the refrigerant lines which can damage the compressor at start-up. If for any reason the unit is laid down, it must be set upright as soon as possible and needs to set for a minimum of 12 hours before starting the compressor. Failure to adhere to the above recommendations will void the warranty.

3.The shipping skid must be removed by tipping the cabinet from side to side. Remove the shipping bolts while the cabinet is held in one direction. Then repeating this procedure when the cabinet is held in the opposite direction.

6

a.On grills with dial thermometers, disconnect the bracket assembly (thumbscrew) before completely removing the air grill.

b.Remove 1/4” hex head screw from each case end panel.

c.Remove the front air grill by lifting the grill vertically. Push up at the bottom of the grill to disengage the lances from the keyhole slots and pull forward.