Victory Refrigeration V-Series Steel Rod Type Pan Slide Racks Refer to Figure, Electric Supply

SECTION 2-INSTALLATION

SECTION 2-INSTALLATION

b.Steel Rod Type Pan Slide Racks (Refer to Figure 2-10)

Steel rod type pan slide racks are also available. They are designed to accommodate 18” x 26” sheet pans as follows:

●Bottom Support Pan Slide Rack on 2” centers

●Lip Support Pan Slide Rack on 1-1/2” centers

Uprights for mounting the steel rod type pan slide racks are factory installed.

Figure 2-8

Angle Type Pan Slides

The appropriate mounting uprights are already installed, when ordered with your cabinet from the factory. Pan slides cannot be attached to the standard shelf pilaster. Pan slide uprights have 1/2” square holes on 1” centers.

To install an individual slide, locate the appropriate square holes at the desired height. A complete section of slides should be installed by starting at the bottom. Insert tabs of the slide into the uprights and apply pressure in a downward direction until the tab fully engages the upright (refer to Figure 2-9).

Figure 2-9

Installing Stainless Steel Angle Type Pan Slides

Figure 2-10

Steel Rod Type Slides

NOTE: Either pan rack can be used on any of one, two or three section refrigerators.

I.Location of Serial Number/Data Plate

The serial data plate is mounted on the upper left interior wall (see Figure 1-2).

J. Electric Supply

The wiring should be done by a qualified electrician in accordance with local electrical codes. A separate ground wire must be supplied for all installations. A properly wired refrigerator or freezer will assure proper operation. Electrical supply requirements are on the cabinet serial/data plate. It is recommended that a direct, properly protected line of the proper size wire be installed from the main supply to your refrigerator or

10