Installation
Installing the Anamorphic | ➤ 1. | Use the |
Lens |
| Mounting Brackets (item #2) to the Anamorphic Lens (item #3). (Do not fully tighten the |
|
| screws yet.) |
| 2. | Use the two |
|
| the Anamorphic Lens assembly to the Base Plate (item #1). |
To avoid clipping the corners of the image, position the anamorphic lens
Tip | as close as possible (ALWAYS within 0.25 inch or closer) to the primary lens. |
| |
| 0.25¨ max. |
Adjusting the Anamorphic ➤ Height (Y) Adjustment:
Lens | 1. | Project a white field on the screen. |
| ||
| 2. | Ensure that the four |
|
| the lens assembly. |
| 3. | Slowly move the anamorphic lens into place so that there are no shadows on the top or |
|
| bottom of the screen: |
Too Low
Correct position
Too High
4.When the height is properly set, tighten the top two
Adjusting the Pitch (Angle): Next, angle the lens to even out any
30 | Vidikron Vision 30 Series Owner’s Operating Manual |