ViewSonic VTMS2431 warranty RS232 Protocol, Male Dsub 9Pin Outside view, Pin # Signal Remark

Other Information

RS232 Protocol

1. Introduction

This document describes the hardware interface spec and software protocols of RS232 interface communication between Viewsonic Commercial Display and PC or other control unit with RS232 protocol.

The protocol divide into three sections:

•Set-Function

•Get-Function

•Remote control pass-through mode

※In below document, “PC” will represents all the control units that can sent or receive the RS232 protocol command.

2. Description

2.1 Hardware specification

Viewsonic LCD communication port in the rear side

(1)Connector type: DSUB 9 Pin Male

(2)Pin Assignment

ENGLISH

Male DSUB 9Pin

(outside view)

1 2 3 4 5

6 7 8 9

Pin #	Signal	Remark
1	NC
2	RXD	Input to LCD Monitor
3	TXD	Output from LCD Monitor
4	NC
5	GND
6	NC
7	NC
8	NC
9	NC
frame	GND

*Use of crossover (null modem) cable required for use with PC.

2.2 Communication Setting

•Baud Rate Select: 9600bps (fixed)

•Data bits: 8bits (fixed)

•Parity: None (fixed)

•Stop Bits: 1 (fixed)

2.3 Command Message Reference

PC sends to Monitor command packet followed by “CR”. Every time PC sends control command to the Monitor, the Monitor shall response as follows:

1.If the message is receives correctly it will send “+” (02Bh) followed by “CR” (00Dh)

2.If the message is receives incorrectly it will send “-” (02Dh) followed by “CR” (00Dh)

Contact ViewSonic service team at: http://www.ViewSonic.com or call our service team: United States 1-800-688-6688, Canada 1-866-463-4775

ViewSonic 45 VTMS2431