Hardwire Conduit Option
a
Remove any loose items in the dishwasher and carefully lay the dishwasher on its back. NOTE: Be careful not to pinch hoses or power cord beneath dishwasher.
c
Loosen ground wire and wires on terminal block.
Loosen strain relief and remove cord.
NOTE: Other items are grounded in this
items must remain grounded.
e | Green |
Ground |
b
Trim Installation Options (not available on all units)
To install dishwasher without trim, remove the 6 screws (3 per side) and remove trim. To attach wiper gasket to dishwasher, pull protective film off adhesive back on wiper gaskets and apply to leading edge of dishwasher frame. Trim gasket to fit.
1a
Remove bottom pan and front plate. Rapid removal of the bottom pan will cause damage to the moisture sensor. To remove the bottom pan for installation and servicing, slowly pull the bottom pan from the unit and disconnect the connector wire from the moisture sensor which is located on the floor of the bottom pan.
Black
d
Green White
Ground Common
UL approved strain relief
Run wires through bottom pan. Using a UL approved | 1b |
| |
strain relief, connect wires to terminal block. |
|
Connect ground wire. |
NOTE: Reinstall front plate and bottom pan.
12 | 13 |