Viking D3 manual Door Replacement and Adjustment, Troubleshooting, Care

Door Replacement and Adjustment

1 2

	2
	1
	2
	3
Reinstall door to range.	Open door completely.

Reinstall hinge trim on both sides.

3 4

Remove pins from holes in hinges. Close door.

5

Care	If the door needs to be adjusted, loosen
	hinge trim screws located in step 2. Adjust
	the screws located between the door
Product	and kickplate using a 5/32” hex head
	allen wrench. After adjustment,
	tighten hinge trim screws.
	42

Troubleshooting

Problem	Possible Cause and/or Remedy
Range will not function.	Range is not connected to electrical power:
	Have electrician check power circuit breaker,
	wiring, and fuses.
Broil does not work.	Temperature control knob is rotated too far
	past broil position.
Oven does not operate in	Door is not shut tight enough for automatic
self-clean.	door latch to lock.
Oven is not clean after self-	Temperature control knob not rotated all the
clean cycle.	way past clean until it stops.
Oven light will not work.	Light bulb is burned out.
	Range is not connected to power.
Igniters will not work.	Circuit is tripped.
	Fuse is blown.
	Range is not connected to power.
Igniters sparking but no	Gas supply valve is in “OFF” position.
flame ignition.
	Gas supply is interrupted.
Igniters sparking	Power supply is not grounded.
continuously after flame
ignition.	Power supply polarity is reversed.
	Igniters are wet or dirty.
Burner ignites but flame is	Burner ports are clogged.
large, distorted, or yellow.
	Unit is being operated on wrong type of gas.
	Air shutters not properly adjusted.
Strong odor and/or smoke	This is normal burn off of insulation and
is noticed first few times	protective oils in oven. This will go away
oven is used.	after using oven a few times.
Oven indicator light on;	Oven is operating properly. Unit will resume
oven will not heat	heating function once it has cooled.

Product Care

43