WIRE SHELVES
The adjustable wire shelves can be removed by lifting up on the shelf |
|
slightly and sliding it out. To reinsert shelves, position the shelf over the |
|
track and slide into place. The shelves are tapered at the back to allow |
|
easy installation. The wine rack will hold 5 bottles of wine. The necks of | Glass shelf |
the bottles alternate front (rear facing) to back (front facing). The rack | separating |
holds three bottles facing to the rear and two bottles facing to the front. | beverage section |
from wine section
Rear
Front
NOTE: The glass shelf separates temperature zone. Do not remove when storing wines.
CLEANING AND MAINTENANCE
Any piece of equipment works better and lasts longer when maintained properlyand kept clean.
Condenser
The condenser tubing inside the cabinet does not require frequent cleaning; however, satisfactory cooling depends on adequate ventilation over the coils. Be sure that nothing obstructs the required air flow openings in front of the cabinet. Spiders and insects can nest in and around the refrigerated beverage center causing damageto the unit. Frequently brush or vacuum lint and dirt from the condenser coils for efficient performance by unscrewing the grill on the bottom front of cabinet.
Cabinet
The cabinet can be washed with mild soap and water and thoroughly rinsed with clear water. Never use abrasive scouring powders.
Interior
Wash interior compartment with mild soap and water. Do not use abrasive powder,solvent, polish cleaner or undiluted detergent.
Stainless Steel Parts
All stainless steel parts should be wiped regularly with hot soapy water. Use a liquid cleaner designed for stainlesssteel when soapy water will not do the job. Do not use steel wool, abrasive cloths, cleansers, or powders. Do not permit citrus or tomato juice to remain on stainless steel surfaces, as citric acid will permanently discolor stainlesssteel.
Brass Parts
CAUTION: All brass parts have an epoxy coating. DO NOT USE BRASS OR ABRASIVE CLEANERS ON THE BRASS PARTS. All brass parts should be wiped regularly with hot soapy water. When hot soapy water will not do the job, use every day household cleaners thatare not abrasive.
Glass Door (Indoor Units only)
Use a glass cleaner or mild soap and water with soft cloth to clean the glass door. Do not use any abrasive powders. On full overlay models, use caution when cleaning near logo area
Door Gasket
The vinyl gasket may be cleaned with mild soap and water,a baking soda and water solution, or a mild scouring powder.
Painted Surfaces
Wash with warm soapy water. DO NOT USE steel wool, abrasive cleansers, ammonia, acids or commercial oven cleaners which may damage the finish.
12