Viking DUAR153 General Information, REVERSIBLE DOORGlass Door Units Only PROFESSIONALSERIES

GENERAL INFORMATION

Unpack

1.Remove banding from bottom of carton. Lift carton up and off of the refrigerated beverage center

2.Remove all tape and packaging material from the outside and inside of the cabinet.

3.Keep all carton packaging until your refrigerated beverage center has been thoroughly inspected and found to be in good condition.

AREA REQUIREMENTS

Units Certified for Indoor Use - (black outer cabinet)

1.Place unit so the front side will be completely unobstructed to provide proper air flow. The unit may be closed in on the top and three sides, but the front MUST BE unobstructed for air circulation and proper operation. Installation should be such that the cabinet can be moved for servicing if necessary.

2.Unit should be in a well ventilated area with temperature above 550F (130C) and below 1100F (430C). Best results are obtained at temperatures between 650F (180C) and 800F (270C) for built-in models and between 65 0F (180C) and 900F (320C) for freestanding models.

3.Provisions for electricity should be determined before placing unit in proper place.

Units Certified for Outdoor Use - (stainless steel outer cabinet)

MUST BE INSTALLED IN AN AREA PROTECTED FROM THE ELEMENTS, SUCH AS WIND, RAIN, WATER(SPRAY OR DRIP).

1.Place unit so the front side will be completely unobstructed to provide proper air flow. The unit may be closed in on the top and three sides, but the front MUST BE unobstructed for air circulation and proper operation. Installation should be such that the cabinet can be moved for servicing if necessary.

2.Unit should be in a well ventilated area with temperature above 400F (40C) and below 1100F (430C).

3.Provisions for electricity should be determined before placing unit in proper place.

REVERSIBLE DOOR(Glass Door Units Only)

PROFESSIONALSERIES

You can change thedoor swing from right toeftl hinge veryeasily.

1.Simply unscrew the top hinge door swing pin with an 1/8” allen drive unit and lift door off of the bottom hinge bracket. Flip the door, remove the light switch activator and replace the light switch activator on the other end of the oord.

2.Remove the door swing pin omfr bottom right hinge. Move the bottom, right hinge bracket to the upper, leftides of the cabinet and fasten it in place with itsoriginal mounting screws.

3.Install the hinge door swing pin into the top right hinge bracket and move the bracket to the lower leftdesi of the cabinet. Fasten it in placewith itsoriginal screws.

4.Place the plastic washer over the bottom door swing pin on the top surface of thebottom, left hinge.

5.Positionthe door on the bottom,left hinge pin and push the door under the top, left hinge.

6.Line-up the top left hinge hole with thedoor bushing hole and insert swing pin. Screw down the oord swingpin with the 1/8” allen drive unit until its head is flush with the top surface ofthe top, left hinge.

7.Reposition thelogo. Your installation is now complete.

Door swing pin

Top hinge bracket

Logo

Bottom hinge

bracket

Note: Hinge bracket location shown is for right-hinge swing.

Light switch activator

5