Electrical Connection
4 | 5 | ||
|
|
|
|
Feed supply cord up through hole in bottom | Attach ground lead (green) |
of range back. | with ground screw that was removed. |
Leveling/Adjustments/Alignment
1 | 2 | ||||
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
Measure the four corners in cutout area to verify if | For uneven or sloped floors, level unit with metal shims |
flooring is level. | only, as the adjustment required may exceed |
| the thread available in the leg. |
6 |
|
| 7 | ||
|
|
|
| 1 | |
|
|
|
|
|
|
Attach line #1 (red) and line #2 (black) | Push supply cord toward terminal |
leads to outside terminal. Attach neutral wire (white) to | block to relieve strain, reattach supply cord strain |
center terminal on terminal block. | relief bracket over supply cord. |
8
3
Move unit into opening.
5
4
3/ | 8 | ” | ) | ||
cm | |||||
|
| ||||
(0. | 95 |
|
| ||
|
|
|
| ||
Check that unit is level side to
side and front to back. Side trim of the high corner
must be 3/8” (0.95 cm) above countertop.
6
1 | 1 |
|
2
Reattach access door.
If leveling is required, move unit out of opening. | Lift unit and prop on wood blocks. |
18 | 19 |
