![](/images/new-backgrounds/1062572/6257223x1.webp)
Final Installation
1 | 2 |
Install backguard. | Slide range into place. Be sure |
|
3 | 4 |
| 3/ | 8 | ” | ) | ||
| cm | |||||
|
|
| ||||
| (0. | 9 | 5 |
|
| |
|
|
|
|
| ||
|
|
|
|
|
| |
Burner caps are packed in styrofoam top pack with the | Check that unit is level side to side |
|
|
|
|
|
grates. Place burner on top of range. Place burner | and front to back. The side trim must be 3/8” (0.95 cm) | |||||
grate on top of burner cap and grate support. | above countertop. If unit is not level repeat steps |
| ||||
Note: Arrow on burner cap must be pointing towards | of “Leveling/Adjustments/Alignment” section. |
|
| |||
back of range. |
|
|
|
|
|
|
Door Replacement and Adjustment
1 | 2 |
Reattach door to range. | Open door completely. Reattach hinge trim. |
3 | 4 |
Remove pins from hole in hinges. | Close door. |
5
If the door needs to be adjusted, loosen hinge trim screws located in step 2. Adjust the screws located between the door and kickplate using a 5/32” hex head allen wrench. After adjustment, tighten hinge trim screws.
22 | 23 |