Before LightingYour Grill
Priorto turning the gas on, inspect the gas supply tubing or hose. Look for evidence of abrasion,cuts, wear and tear,or other damage which could require replacement prior to use. Make sure all burner control knobs areoff. Do not attempt to light the burners if the smell of gas is present.
Check the connection with a soap and water solution after attaching the hose. Make surethere is gas in the tank and the tank is upright.
_, CAUTION: Wait at least5 minutes before relighting a hot grill to allow any accumulated gas to dissipate. Keep a spray bottle of soapy water nearthe gas supply valve and check the connections for gas leaksbefore each
use.
To properly installthe flavor generator plates:
Placethe stainlesssteel perforated flavor generator platesso that the front and reartabs reston the grill frame. The flashtube must be accessiblethrough the plates. Ifthe flash tube
is not accessible,the flavor generator plates are not properly installed.
Flash Tube
Using the Grill with Outdoor Approved Hoods
•Outdoor approved hood models should be installed in a covered non- enclosed area. They should also be protected from natural elements (suchas rain)as much as possible.
•Alwaysturn the outdoor hood on to the HI position before lighting the grill.
•Keep the grill canopy closed as much as possiblewhen cooking so smoke is exhausted out the backof the grill. This allows for optimum performance of the hood.
•During breezyconditions, the performance of the outdoor hood may be compromised.
Ughtingthe Grill (T-SeriesModels)
When lighting a burner, always pay close attention to what you are doing. Becertain you are pressingthe battery ignition button
6
