Viking VGSC manual Leveling/Adjustments/Alignments cont, Anti-tip Device Installation cont, Danger

Leveling/Adjustments/Alignments (cont.)

7

Anti-tip Device Installation (cont.)

4

Set the high corner of range so that the top of side trim is 3/8” (0.95 cm) above countertop. Level range to high corner.

Anti-tip Device Installation

WARNING

TIPPING HAZARD

To reduce the risk of property damage or personal injury; install anti-tipping device provided in accordance with the installation instructions in this document. Device must be engaged properly to prevent product from tipping over.

1

Measure

ment(A )

Measure from floor to bottom

of the anit-tip opening located on the back of range.

This will be measurement (A).

Attach bracket with

mounting hardware provided.

Connecting Gas & Electric

DANGER

GAS LEAK HAZARD

To avoid risk of personal injury or death; leak testing of the appliance must be conducted

according to the manufacturer’s instructions. Before placing appliance in operation, always check for gas leaks with soapy water solution.

• DO NOT USE AN OPEN FLAME TO CHECK FOR GAS LEAKS.

Note: Refer to electrical and gas requirements section for proper installation information.

2

3-

5

(

/

8

9.

”

2c

m)

t

(A

)

en

m

)

e

3

cm

a

s

u

r

(1

.

e

2”

M

/

1

+

Locate anti-tip bracket on rear wall with the top left corner at

measurement (A) plus 1/2” (1.3 cm) from the floor and 3-5/8” (9.2 cm) from where the right side of range (facing range) is to be located.

3

Mark and drill holes where bracket will be located.

1

Connect gas and electrical. Before placing appliance in operation, always check for gas leaks. This must be performed by your dealer,a qualified licensed plumber,or gas service company.

16 17