Viking VGSC manual Final Preparation, Service & Registration, Performance Checklist

Final Preparation

Service & Registration

•All stainless steel body parts should be wiped with hot, soapy water and with a liquid cleaner designed for this material.

If buildup occurs, DO NOT use steel wool, abrasive cloths, cleansers, or powders!

If it is necessary to scrape stainless steel

to remove encrusted materials, soak with hot, wet cloths to loosen the material, then use a wool or nylon scraper. DO NOT use a metal knife, spatula, or any other material tool to scrape stainless steel! Scratches are almost impossible to remove.

Only authorized replacement parts may be used in performing service on the appliance. All servicing should be referred to a qualified technician.

Contact Viking Range Corporation, 1-888-VIKING1 (854-4641), for the nearest service parts distributor in your area or write to:

VIKING RANGE CORPORATION

PREFERRED SERVICE

Performance Checklist

A qualified installer should carry out the following checks:

1803 Hwy 82W

Greenwood, Mississippi 38930 USA

The serial number and model number for your appliance can be found by opening the door and looking under the control panel.

hCheck top burner ignition. See drawing for proper flame height on HI. The low flame should light at every port.

1-1/2”

(3.8 cm)

3/8”

(0.95 cm)

h For self-cleaning models check self-clean

function—door will lock in approximately 30

seconds, the center and outside broil

elements will turn on and the bake element

will turn on at partial power. Check broil

elements through window to make sure

they are on, then abort self-clean cycle to

Record the following information indicated below. You will need it if service is ever required.

Model number ____________________________________________________________________________________

hCheck oven bake function—bake burner on full power.

unlock door.

hCheck Convection bake function—bake and broil burners the same with the convection fan on (VGSC self-clean models).

hCheck convection broil function—broil burner at full power with convection fan on (VGSC self-clean models).

hCheck convection fan function—convection fan comes on when switch is turned on (VGCC models).

NOTICE

When conducting performance test, DO NOT run self-clean cycle for more than 10 minutes with oven racks inside oven. This could cause them to discolor due to the high temperature required for self-cleaning.

Serial number _____________________________________________________________________________________

Date of purchase __________________________________________________________________________________

Date installed ______________________________________________________________________________________

Dealer's name _____________________________________________________________________________________

Address ___________________________________________________________________________________________

These installation instructions should remain with the unit

for future reference.

20 21