Electrical & Gas Requirements
Electrical & Gas Requirements
Electrical Requirements
Check your national and local codes regarding this unit. This range requires 120VAC/60 Hz; 4 ft. (121.9 cm),
In Massachusetts: A “T” handle type
manual valve must be installed in the gas supply line to the appliance.
IMPORTANT: Any conversion required must be performed by your dealer or a qualified licensed plumber or gas service company. Please provide the service person with this manual before work begins.
Flexible Connections:
If the unit is to be installed with flexible couplings and/or
In Canada: CAN
In Massachusetts: This appliance must be installed with a 36”
WARNING
ELECTRICAL SHOCK
HAZARD
To avoid the risk of electrical shock, personal injury or death;
verify electrical power is turned off at the
Pressure Regulator:
• All |
equipment must have a pressure regulator |
on the incoming service line for safe and |
efficient operation, since service pressure |
may fluctuate with local demand. External |
(7.0 cm)
2” dia.
(5.1 cm)
breaker box and gas supply is turned off until the range is installed and ready to operate, installation by an authorized installer only.
Gas Connection
The gas supply (service) line must be the same size or greater than the inlet line of the appliance. This range uses a 1/2” (1.3 cm) ID NPT (Sch40) inlet. Sealant on all pipe joints must be resistive to LP gas.
The range is designed specifically for natural gas or liquid propane (LP) gas. Before beginning installation verify that the model is compatible with the intended gas supply.
Manual shut-off valve:
This
an emergency. Any opeing behind the range shall be sealed.
| regulators are not required on this range |
| since a regulator is built into each unit at |
| the factory. Under no condition bypass |
| this |
• | Manifold pressure should be checked with |
| a manometer, natural gas requires 5.0” |
| W.C.P. and LP gas requires 10.0” W.C.P. |
| Incoming line pressure upstream from the |
| regulator must be 1” W.C.P. higher than |
| the manifold pressure in order to check |
| the regulator. The regulator used on this |
| range can withstand a maximum input |
| pressure of 1/2” PSI (14.0” W.C.P.). If the |
| line pressure is in excess of that amount, a |
| step down regulator will be required. |
• | The appliance must be disconnected from |
| the gas supply piping system during any |
| pressure testing of that system. |
Gas connection in this area
(6.4 cm)
(4.4 cm)
23- |
| 7/16” | |
| |||
(59.5 cm) | (78.9 cm) |
(71.9 cm)
(11.1 cm)
Gas or electrical connection in this area
10 | 11 |