VIKING COMPONENTS 56K USB MODEM USER’S GUIDE
Software Installation
Once the Viking USB fax/modem is installed, you will need to install the software necessary to communicate with the fax/modem. This section will cover the steps necessary to configure your computer’s operating system. Please proceed to the following pages for your computer’s operating system:
• Windows 95 (OSR2) | page 7 |
• Windows 98 | page 9 |
Windows 95 (OSR2) Software
1.You will be prompted with the “New Hardware Found” message. Click on the “OK”button.
3.Your system will retrieve the nec- essary drives off the driver diskette. Note that the “Device Found” has changed from “Unknown Device”to the “Viking USB Modem Board.” Then click on the “Finish”button.
2.The “Update Device Wizard” win- dow will appear. The device found should read: “Unknown Device.” With the “Viking USB Modem Installation Disk” still in the floppy drive, click on the “Next”button.
Note: If the diskette can not be located, the drivers can be down- loaded from our Web site at: www.vikingcomponents.com
7Chapter 3
